![]() ![]() The Kreg Tool Company has a lot of other worthwhile tools in their cache. Using a Kreg Jig Jr makes easy work of building and assembling your own custom cabinets. At this point, I repeated the same process on the opposite side of the cabinet until all of my joints were secure. This will help hold the shelf in the correct position as you begin to screw it into place. Take a straight scrap piece of wood and clamp it into place so that the edge lines up with your shelf marks. One side has a round flat surface, while the other side has a pin just large enough to fit inside one of the pocket holes.įollowing the same principles as we’ve already discussed, it’s really easy to install a fixed shelf using the Kreg tools as well! Measure and mark where the fixed shelf will be placed. Kreg makes another kind of clamp that makes assembling a lot easier. into place, then drilled the four evenly spaced pocket holes for the first joint. Using the Kreg Face Clamp, we secured the Kreg Jig Jr. ![]() The cabinets we are building are about 20″ deep, so we chose to connect each joint with 4 separate pocket hole screws. To set the collar to the correct depth simply slide the collar onto the drill bit, place the bit into its holder in the case (It has built-in gauge markings), slide the collar to the same measurement as the Kreg Jig Jr, and tighten the allen screw on the collar. The collar acts as a depth gauge for drilling into woods of varying thickness. case, you’ll find a drill bit with an adjustable collar. It easily attaches to the Kreg Jig Jr and it’s easily adjustable for clamping different thickness woods. Most any bar clamp or c-clamp will secure the Kreg Jig Jr in place, but I’ve found that when I’ve got multiple pocket holes to drill, I prefer using a Kreg Face Clamp. The grey sliders have small feet that hang down to act as a lip to butt up against the edge of your wood. So, if you are using 3/4″ plywood for your project, you’ll need to set both sliders to the 3/4″. Those numbers correspond to the thickness of the wood that you’re using for your project. ![]() On the bottom side of the Kreg Jig Jr, there are adjustable sliders that have numbers on them. It’s a reliable and easy to use tool for making strong and dependable joints for all of your woodworking projects. We are in the process of building some cabinets for our pantry renovation, so it’s a great time to write a tutorial on how we use the Kreg Jig Jr.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |